Fewer complications and fewer moving parts mean less things to go wrong.
Just to name one, they're a lot less complicated than automatics.
#Short throw shifter wrx factory manual#
Driving a manual transmission is not only more rewarding than driving an automatic transmission, but there are a number of benefits to manual transmissions. But once you have truly mastered the art, you will never turn back. Learning to drive a stick can be both exciting and frightening. What is a Short Shifter and What Does It Do?
Reverse removal steps to complete install. Reinstall the shifter back into the shifter assembly and re-install the reverse lock out.Ģ3.
#Short throw shifter wrx factory install#
Take the shift adapter off the factory shift arm and install on the new shifter.Ģ2. Use a snap ring pliers to remove the snap ring. Then pull the factory shifter arm out.Ģ0. Remove O-Ring and use punch to remove roll pin. With sub-assembly out remove the 2 bolts at the bottom of the assembly holding the cover.ġ8. Push the bolts out and remove the shifter from the sub- assembly.ġ7. Then remove the 2 nuts holding the bolts in place for the shifter sub-assembly. Push bolt out and remove the side shift arm.ġ6. Remove the nut holding the side shift arm bolt. From the assembly unscrew the wire harness tabs and unbolt the bolt holding in neutral lock plunger.ġ5. Unclip the 2 wiring harness attached to the shifter assembly and remove.ġ4. Remove the 4 bolts holing in the shifter assembly.ġ3. Then push the tab holding the side trim in place.ġ2. With trim removed unscrew the 2 screws at the base of the side trim plastic. Then remove shifter trim and boot by pulling back.ġ1. Remove the bolts and move console back.ġ0. Gently pull up on the side and it will release allowing access to the bolt. 2 are covered by foam under the arm rest. The center console will need to be loosed and pulled back.ĩ. Unbolt the nuts on the bottom shifter assembly.Ĩ. Disconnect the main shift cable by spreading apart the locking spring.Ħ. Locate the side shift cable and gently pry it off the mount.ĥ. Unbolt the bolts holding the shifter cover.Ĥ. Unbolt the 4 bolts holding the heat shield and remove.ģ. Place the car on a lift to gain access to the underside of the vehicle.Ģ. This Install Guide is intended to help with the installation of the Agency Power Blow Short Throw Shifter on a 15+ Subaru WRX.ġ.
0 kommentar(er)
